filter were changed and on 23.04.2012, fan assembly,
sensor water temperature, air filters were changed. On 24.04.2012, the
technician of Saini Agro Service, Hajipur, Dasuya ... tractor was standing and the technician changed the filter,
water temperature sensor and coolant water and while they were
testing after changing the parts
handset had seven connecting lines for recording resistance of
tissue impedus sensor, temperature sensor and energy conductor and urethral
and rectal temperature sensor.
Tissue conductor ... self-illuminating figures clearly indicating input power, impedance
of the tissue and temperature for each channel. It also illuminates time set for
treatment and temperature
technician has observed that the remote kit, display board assembly, temperature sensor and coil sensor are defective. Thereafter, the Petitioner wrote a letter to Opposite ... reveal that there were defects in Remote Kit, Display Board Assembly, Temperature Sensor and Coil Sensor. Even assuming that an attempt was made on behalf
goods imported by the appellant is a combination of pressure and temperature sensor allowing simultaneous measurement of these two parameters in a single mounting well ... controlling temperature....
(ii) Not elsewhere specified."
The produce literature as reproduced above shows that the goods in question are pressure and temperature sensors
during the inspection, it was found that:
1. RPM and oil temperature sensor were not functioning.
2. CO-correction software was not installed
flow through the windings.
The choke has been equipped with a temperature sensor and a temperature monitoring relay. The relay is linked into the control ... flow through the windings, the choke was equipped with a temperature sensor and a temperature monitoring relay, the aforesaid improvement which were aimed at preventing
spring loaded suction and
discharge valves. Safety valves, pressure and temperatures
sensors, gas & flame detectors are installed to ensure safe
compression of gas.
Further
Blower Motor
2. Impeller/Blower fans
3. Expansion Valve
4. Temperature sensor
5. Cooling coil
6. Plastic cover with Grills
7. Switches for thermostat control ... passes over the evaporator and it is reheated to room temperature by the condenser. The air then re-enters the room, absorbs moisture again
control arrangement, by pass
arrangement for pyro gas, installation of gas sensors,
pressure, temperature gauges at reactor & storage
tank, alarm system, facility for flaring ... pyro gas from
reactor door to primary condenser, installation of gas
sensors, pressure, temperature gauges at reactor &
storage tank, alarm system, flaring of entire
account of completely different reason being
related to the temperature sensor. The OP No. 1 stated that the
vehicle had run on that date
