Section 10k(6) in The Standards of Weights and Measures (General) Rules, 1987

[Cites 0, Cited by 0] [Section 10k] [Entire Act]

Union of India - Subsection

Section 10k(6) in The Standards of Weights and Measures (General) Rules, 1987

(6)Maximum permissible errors

(i)Values of maximum permissible errors on verification/re-verification The maximum permissible errors allowed for increasing or decreasing loads shall be as given Table 43.

TABLE 43m

Maximum permissible errors on verification/re-verification	For loads m expressed in verification scale intervalse
	Class I	Class II	Class III	Class III
±0.5e	Min≤m≤50000	Min≤m≤5000	Min≤m≤500	Min≤m≤50
±1e	50000<m≤200000	5000<m≤20000	500<m≤2000	50<m≤200
±1.5e	200000<m	20000<m≤100000	2000<m≤10000	200<m≤1000

(ii)Values of maximum permissible errors in inspection

The maximum permissible errors during inspection shall be twice the maximum permissible errors allowed on verification.

(iii)Basic rules concerning the determination of errors

(a)Influence factors

Errors shall be determined under normal test condition. When the effect of one factor is being evaluated, all other factors are to be kept relatively constant, at a value close to normal.

(b)Maximum permissible errors for net values

The maximum permissible errors apply to the net value of the load for every possible tare load, except preset tare values

(c)Tare weighing device

The maximum permissible error for a tare weighing; device are the same, for any tare value as those of the instrument, for the same value of load.

Legal Document View

Unlock Advanced Research with PRISMAI

Union of India - Subsection

Section 10k(6) in The Standards of Weights and Measures (General) Rules, 1987