Union of India - Act
Use of Very Low Power Radio Frequency Devices or Equipments for Inductive Applications (Exemption from Licensing Requirement) Rules, 2015
UNION OF INDIA
India
India
Use of Very Low Power Radio Frequency Devices or Equipments for Inductive Applications (Exemption from Licensing Requirement) Rules, 2015
Rule USE-OF-VERY-LOW-POWER-RADIO-FREQUENCY-DEVICES-OR-EQUIPMENTS-FOR-INDUCTIVE-APPLICATIONS-EXEMPTION-FROM-LICENSING-REQUIREMENT-RULES-2015 of 2015
- Published on 16 September 2015
- Commenced on 16 September 2015
- [This is the version of this document from 16 September 2015.]
- [Note: The original publication document is not available and this content could not be verified.]
1. Short title and commencement.
2. [ Application. [Substituted by Notification No. G.S.R. 996(E), dated 5.10.2018 (w.e.f 16.9.2015).]
- These rules shall be applicable in the 302 to 435 KHz, 855 to 1050 KHz and 1.89 to 2.31 MHz frequency bands.]3. [ Definition. [Substituted by Notification No. G.S.R. 996(E), dated 5.10.2018 (w.e.f 16.9.2015).]
- In these rules, unless the context otherwise requires, -4. [ Exemption. [Substituted by Notification No. G.S.R. 996(E), dated 5.10.2018 (w.e.f 16.9.2015).]
- Notwithstanding anything contained in any law for the time being in force, no licence shall be required by any person to establish, maintain, work, possess or deal in any wireless equipment for the purpose of usage of Very Low Power Radio Frequency Devices or Equipments for Inductive Applications (wireless charging etc.) in the 302 to 435 KHz, 855 to 1050 KHz and 1.89 to 2.31 MHz frequency bands on non-interference, non-protection and shared (non-exclusive) basis, with the maximum Field Strength Limits as specified in the Table below, namely : -Technical Characteristics| S.No. | Frequency Range | Maximum Field Strength Limits |
| 1 | 302 to 435 KHz | -15 dBuA/m (H-Field Strength) at 10 metres |
| 2 | 855 to 1050 KHz | -15 dBuA/m (H-Field Strength) at 10 metres |
| 3 | 1.89 to 2.3 MHz | -15 dBuA/m (H-Field Strength) at 10 metres |
5. Conditions.
- The exemptions granted under rule 4 shall be subject to the following conditions, namely: -| Section-A- Applicant | ||
| 1. | Name of manufacturing agency applying forequipment type approval | : |
| 2. | Postal Address of manufacturing Agency | : |
| 3. | Name of Product andthe productIdentification (model number etc.) | : |
| Section- B- Details of Transmitter | ||
| 1. | Frequency range | : |
| 2. | No. of preset switchable channels | : |
| 3. | No. of voice /Data/TV Channels(In case of multi- channel equipment) | : |
| 4. | Tx-Rx channelseparation(In case of Duplex/multi-channel equipment) | : |
| 5. | Adjacent channelseparation(In case of multi-channel equipment) | : |
| 6. | Frequency stability | : |
| 7. | Spurious/ Harmonic radiations | : |
| (i) Carriersuppression(In case of carrier suppressed systems) | : | |
| (ii) Unwanted sideband suppression(In case of SSB systems) | : | |
| (iii) 2nd Harmonic radiations | : | |
| (iv) 3rd Harmonic radiations | : | |
| 8. | Max. Frequency Deviation | : |
| 9. | Mode of Emission | : |
| 10. | Bandwidth of Emission | : |
| 11. | Test Tone Deviation | : |
| 12. | Base band frequency(In case of multi-channel equipment) | : |
| 13. | Type of modulation to be required | : |
| 14. | Pre-emphasis | : |
| 15. | Power output(At the input of antenna) | : |
| 16. | Any other information | : |
| Section-C- Details of Receivers | ||
| 1. | Frequency range | : |
| 2. | Mode of reception | : |
| 3. | Spurious response of receiver | : |
| 4. | Sensitivity | : |
| 5. | Frequency stability | : |
| 6. | (a) Effective noise temperature | : |
| (b) Threshold input level | : | |
| 7. | Intermediate frequency | : |
| 8. | De-emphasis | : |
| 9. | Selectivity | : |
| 10. | Any other particulars | : |
| Signature of the applicant | ||
| Place : | ||
| Date : | ||
| (Note: Separate application should besubmitted for each type of equipment.) |